U-Joint Flange Yoke – 1310

1310 Flange Yoke

1310 U Joint Flange Yoke for Driveline Conversion and Swap Applications

The 1310 flange yoke is a reliable driveline component designed to convert flange style outputs to a 1310 series U joint driveshaft connection. This allows builders to run a simple serviceable one piece driveshaft using widely available components across swap and custom builds.

Fully compatible with FABbot output flange adapters this yoke provides a cost effective and proven solution for street and moderate performance applications.

Engineered for Simplicity Compatibility and Reliability

Designed for 1310 series U joint driveshafts
Compatible with all FABbot output flange adapter systems
Converts flange output to standard U joint connection
Simplifies custom driveshaft builds
Built for street and moderate performance applications

Technical Specifications

U joint series 1310
4 bolt flange pattern
Bolt circle 3.750 inch
Bolt hole diameter 0.438 inch
Pilot diameter 2.750 inch
Flange diameter 4.625 inch
U joint cap diameter 1.062 inch
U joint width approximately 3.219 inch
Flange face to U joint centerline 1.375 inch

Fitment and Compatibility

Compatible with transmission differential and transfer case flange outputs
Designed for use with FABbot flange adapter systems
Requires matching bolt pattern and pilot diameter

What You Will Need

Matching 4 bolt flange output
Driveshaft built with 1310 series U joints
Driveshaft length matched to chassis

Built for Reliable Real World Performance

This flange yoke provides a clean and effective driveline solution for builders who want a simple reliable and cost efficient setup. It integrates seamlessly with adapter systems and supports a wide range of swap and custom applications.