1418 Ram 2500 4WD FOX 2.0 Adventure Shocks 45″ Lift (Set of 4)

Dial in on-road comfort and controlled off-road handling with FOX 2.0 Adventure Series monotube IFP shocks. Built for 1418 Ram 2500 4WD with 45" front and 2.54" rear lift. 2.0" smooth-bore alloy bodies and 5/8" heat-treated hard-chrome shafts deliver durability and fade-free performance.

Vehicle Fitment (YMM)

Key Specs

• Series: FOX 2.0 Adventure Series (IFP monotube)
• Body: 2.0" smooth-bore, seamless alloy with thick silver powdercoat
• Shaft: 5/8" heat-treated hard-chrome plated
• Valving: Vehicle-specific; tuned for lift systems (works beyond Zone kits)
• Bushings: Nitrile rubber for articulation
• Lift Range: Front 45", Rear 2.54"
• Design Benefit: IFP separates oil from nitrogen charge for fade-free performance

Whats Included

• (2) Front FOX 2.0 Adventure Series shocks (for ~45" front lift)
• (2) Rear FOX 2.0 Adventure Series shocks (for ~2.54" rear lift)
• Installed bushings

Check your lift heights and rear suspension type before ordering. Not compatible with factory rear air suspension.

Installation

• Difficulty: EasyIntermediate (bolt-on)
• Tools: Basic hand tools, torque wrench, jack/stands
• Steps (general): Safely support axle; remove OE shocks; verify compressed/extended lengths vs. lift; install new shocks (one corner at a time); torque hardware to spec with vehicle at ride height; road test; re-torque after 50100 miles.
• Tips: Cycle suspension to confirm brake line and sensor slack at full droop; inspect mounts/bushings; do not use an impact on shock shafts.

If you run into any trouble during install, give us a call were here to help answer questions and get you back on track.

Shop Notes

• These lengths/valving target the listed lift range; pairing with matched front/rear lift yields best results.
• Not for trucks equipped with factory rear air suspension.
• Ask us about FFS in-house install

Prop 65 Warning: Cancer and Reproductive Harm see www.p65warnings.ca.gov/.