1.25″ Standard Tube Adapter Right Hand 1.5(ID) 12(TPI)

1.25" Standard Tube Adapter Right Hand, 1.50" ID, 12 TPI Weld-in threaded bung for link-suspension builds. Designed so most of the heim shank sits inside the tube for added support by both the bung and the tubeour preferred way to build the bottom-side parts that see the dirt first. This model fits 1.25" RH heim joints.

Key Specs

• Type: Weld-in threaded tube adapter (bung) for link suspension
• Thread: 1.25"-12 TPI, Right-Hand
• Tube ID: 1.50" (1-1/2")
• Heim Compatibility: 1.25" shank rod ends (RH)
• Design Feature: Extended shank engagement so the heim is supported by both the bung and tube
• Material: Steel (not chromoly) strength comes from the engagement/design
• Use Case: Ideal for lower links / high-abuse locations
• Sold: Individually
• Handed Pairing: Use with an LH mate if you want on-bar adjustability

Note: This listing is for Right-Hand thread. Confirm your rod ends and match RH/LH as needed.

Whats Included

• (1) Weld-in threaded tube adapter 1.25"-12 TPI, Right-Hand, fits 1.50" I.D. tube

Sold individually. Order quantity to match your link set and thread directions.

Installation

• Difficulty: Intermediate (welding required)
• Welder Setup: Correct heat/input start your puddle on the tube to avoid warping threads
• Do Not: Do not weld with the rod end threaded inside different cooling rates can seize parts
• Cool Down: Allow the bung/tube to cool completely before threading rod ends into the adapter
• General: Prep/clean tube I.D.; ensure concentric fit; tack, check alignment, then stitch-weld in short passes

Ream/clean threads after welding if needed. Anti-seize is recommended on initial assembly.

Pair RH with an LH adapter on the opposite end to enable on-bar length adjustments without removing the link. Ask us about FFS Professional Installation services.

Prop 65 Warning: This product can expose you to chemicals including lead (www.P65Warnings.ca.gov).